Ridgid ratchets and handles for die heads, hole saw holders and drill guides
Ridgid ratchets and handles drive the die heads of manual threaders, and together with the hole saw holders and drill guides in this category they form the basis for threading and cutting holes by hand or with a drill. Installers and maintenance technicians use them to thread pipe and to drill holes for pipe and cable passages. The category belongs to the Ridgid machining tools.
Each ratchet fits a fixed series of cutting heads: there are ratchets with a lever for 00-R and 00-RB, for 11-R and for 111-R. So check first which cutting heads you use. For the 00-R thread cutter there are a metal housing and a metal case, and a drive rod sets a thread-cutting iron in motion.
For hole saws there are holders per range, such as R5 for 14 to 30 mm and R6 for 32 to 38 mm, plus a holder with a solid 1/2" shank. Drill guides 30 mm long keep the pilot drill straight; their outer diameter runs from 7.1 to 14.3 mm.
- Accessory/Part type: Storage chest
- Min. diameter: 32 mm
- Max. diameter: 152 mm
- Shank size: 3/8 inch
- Min. diameter: 14 mm
- Max. diameter: 30 mm
- Shank size: 9 mm
- Min. diameter: 14 mm
- Max. diameter: 30 mm
- Shank size: 6 mm
- Min. diameter: 32 mm
- Max. diameter: 38 mm
- Shank size: 11 mm
- Accessory/Part type: Drive shaft
- Accessory/Part type: Guide sleeve
- Accessory/Part type: Guide sleeve
- Accessory/Part type: Guide sleeve
- Accessory/Part type: Guide sleeve
- Accessory/Part type: Guide sleeve
- Accessory/Part type: Guide sleeve
- Accessory/Part type: Guide sleeve
- Accessory/Part type: Guide sleeve
- Accessory/Part type: Guide sleeve