Mounting and disassembly tool sets for automotive workshops

Removing seals, O-rings, clips and elastic belts from tight engine bay locations without damaging surrounding components requires purpose-built picking and prying tools. Hook and pick sets provide a selection of angled, straight and offset tips that reach behind retaining rings, lift seal lips and extract circlips from grooves that fingers and standard screwdrivers cannot access.

An 8-piece chopper set extends the range with broader blade profiles for cutting away hardened gasket material and scraping mating surfaces clean before reassembly. Crochet sets with four specialised hook profiles handle the fine extraction work needed on wiring harness grommets, vacuum hose connectors and small snap-fit clips found throughout modern vehicle interiors and engine management systems.

For drivetrain work, a dedicated CV boot expander stretches replacement drive shaft sleeves over the joint housing without tearing the rubber, which is a common failure point when using improvised tools. Belt mounting and dismounting tools simplify the removal and refitting of elastic auxiliary drive belts that have no manual tensioner, preventing the belt damage that often results from levering with screwdrivers. These sets keep automotive technicians equipped for the varied disassembly tasks that arise during servicing, repairs and component replacement.

Filter