Non-standard impregnated, pre-compressed foam tape for sealing joints and connections on the inside or as a backing pad for outdoor use.
Ideal for placing exterior carpentry behind striker, if further sealed with eg Soudaseal 215 LM.
Properties
Acoustic and Thermal Insulator
Dustproof
windproof
Vapor permeable
Meets the requirements according to DIN4108 (EnEv) and the recommendations of the RAL mounting
Easy to apply
Self-adhesive on one side (= mounting aid)
Does not cause any contamination of the joint edges
Neutral and odorless
Permanently elastic and paintable.
Applications
As a joint finish in masonry, between prefab elements and concrete walls.
Soudaband Acryl 300 can also be used as secondary sealing of the joint between window frames and wall.
Must be covered afterwards, eg with Soudaseal 215LM.
Instructions
Soudaband Acryl 300 is easy to apply without special tools. The use of a spatula, knife or scissors and possibly wooden wedges is sufficient. After determining the joint width, the corresponding tire size is then selected. The joint flanks must run parallel and be free of construction dirt and/or cement residues. When unrolling Soudaband, take at least 1 cm extra. In the case of vertical joints, the installation of the Soudaband starts at the bottom. Fix the swelling tape by pressing the self-adhesive side against a joint side using a putty knife. After application, the pre-compressed strip will swell, causing it to press against the joint flanks and thus fill the joint, with any irregularities. When butting two Soudaband ends, it is important that they are flush on the visible side and that the two ends connect tightly to each other. Provide an excess length per strap and do not stretch it when installing.
Features for SOUDAL SOUDA TAPE ACRYLIC 300 ANTHRACITE 15 / 3-12 MM