designed for a pressure force of 10 t, 12 t or 15 t
the pressure piece can be replaced by a tip and extended if necessary.
the small pressure spindle is secured with a knock-out protection against unintentional removal. Preparing for use: 1. Before use, check that the thin pressure spindle is screwed far enough out of the cap so that the pressure piece is in the starting position in the hydraulic cylinder. 2. Unscrew the cap from the spindle body. To do this, first unscrew the locking bolt. 3. Screw the spindle body from below into the tractor's cross member, until it protrudes approx. 60 mm from the cross member. 4. Screw the cover onto the main spindle as far as it will go, tighten the locking bolt. Use and working method: eg HSP3 5. Fit the trigger and pre-tension the main spindle using a ring or spanner. 6. Screw the thin pressure spindle into the cap. The hydraulic mechanism is now working The stroke of the pressure piece in the hydraulic cylinder is max. 12 mm. The hydraulically separated component can then be completely removed by tightening the main spindle with the cap. 7. After use, turn the thin pressure spindle back into the starting position and push the pressure piece back into the hydraulic cylinder.
Features for GEDORE 1.06 / HSP3 HYDRAULIC SPINDLE 15 T